Search results

1/2 ' unions

Can you still get lead and oakum?

Where is the shutoff?

I have seen a lot worse. Hook it up and pressure test it.

also no venting,Studor is on top of 1 1/2" tee.

Shower at the bottom of pic, then toilet with sink to the left of 4" pipe. It should be 12 1/2" from center of 4" back to front of bottom plate. 15" minimum either side of center line of toilet.

Twice the pipe diameter should be,but looks ok.

Moen

Its a Moen and takes a 1225 cartridge. Google moen cartridge replacement.

I like the 2x1 1/2x 1 1/2 tee idea but you cant disassemble the p-trap. I used to use an 1 1/2 san tee like that but without a baffle in the tee I was getting complaints about food coming up in the other bowl occasionally. I cant discharge into disposal either. I like seeing work from other...

You probably wont get a disposal in there at that height,gonna be close.

18 3/8 is pretty high for a center line. I am always at 15" or less. Undermount sinks,granite,extra deep bowls yada yada yada

you also need to expose the closet collar, wax ring goes to collar not onto finished floor.Floor does not go around closet bolts either.

you need a 10" toilet, google it.

Throw a Fluidmaster ballcock on the supply and keep the float held up. Done till morning.

Test plug, but brace it to the floor above with a 2x4 or similar. Cheap insurance, because I know;)

yup, says Stanadyne on the eschutcheon and screws match.

Moen 1225

FIP

I'd spend the money on a new tank.