Search results

will contact moen thanks for your help

Jeff i do not think the brand etc would any difference Moen single handle and there is an unused spray head thanks

The plastic bits in the old one fell apart so we bought a new one. Kitchen faucet/tap. we vaguely remember the last time we did this we had to remove bits of the inside of the new one to get water pressure. any ideas? thanks for your help

thanks for your help

gas water heater

the PRV spat out water - just a little and rheem said to replace it. they paid. why dont i get notifications of your helpful replies?

I assume you have not seen this before? thanks PS administrator - I did not get a notification in my email

the RHEEM tank is 6 months old. see the black stuff inside. is that usual? i suspect the fella in the factory sprayed the inside of the tank AFTER this prv was installed. thanks all

does it look like a washer is missing? thanks all

the problem is not solved yet thanks Could be the valve body is bad - does this mean a new tap? thanks

i have seen post saying they go on the hot pipe and others on the cold pipe! is there a correct way? thanks

thanks all a picture of one of the tanks that they would fit would be nice. note to moderator: i selected instant email notification, but got none. thanks

Rheem have sent us a replacement pressure relief valve. but the plumber over the phone says we need a thermal expansion tank. we did not have any problems with the old tank (13 years old) is there room? will the tank need to be rotated? then the drain from the relief valve will be in the wrong...

one should remember to put the stopper in so all those bits do not fall down the drain! and the nut holding in the cartridge... is it that big gray bit? thanks all

thanks all

https://www.youtube.com/watch?v=YneOjcOnrw4

thanks how do i take the handle off?

this a photo looking upwards from the vanity under the sink. see those three holes? when the tap(faucet) is fully on it leaks from there. we tried tightening those nut on the hold down brackets, but i doubt that is the problem. it is a moen tap. it is not dribbling from around the aerator how do...

also he replaced the old shut off valve.

well $280 later the PRV is replaced - simple job with easy access. but now it seems to be working. thanks all PS those copper looking bands - are they what they use now?