ResqDogz
Member
Well, the copper lines some "professed plumber" buried under concrete in the garden level of my 1900 Victorian back on the mid-80's finally started leaking: Time to run the PEX lines overhead, rather than buried copper... and eventually extend 1/2" lines of the manifold up one floor to the kitchen, and then port 3/4" hot/cold feeds up two floors to redo the entire master bathroom.
Acquired four of Wirsbo-Uponor P2110500 Manifolds (new) a $30 each (currently en route to me), but need to adapt into 3/4" copper feed: Does anyone know the specific thread for the 1" male flow-through ports on the end of these?
Hoping to find a reducer from the 1" port to 3/4", so all I need do is couple the copper and 3/4" PEX lines together, as opposed to deploying a 1" PEX off the port, then adding an inline reducer to 3/4" PEX, and finally connecting to the 3/4" copper...
Uponor can't even find this manifold in their catalogs, anywhere...
Any suggestions (or source for NOS parts) would be most gratefully appreciated!
Thanks!
Steve
Acquired four of Wirsbo-Uponor P2110500 Manifolds (new) a $30 each (currently en route to me), but need to adapt into 3/4" copper feed: Does anyone know the specific thread for the 1" male flow-through ports on the end of these?
Hoping to find a reducer from the 1" port to 3/4", so all I need do is couple the copper and 3/4" PEX lines together, as opposed to deploying a 1" PEX off the port, then adding an inline reducer to 3/4" PEX, and finally connecting to the 3/4" copper...
Uponor can't even find this manifold in their catalogs, anywhere...
Any suggestions (or source for NOS parts) would be most gratefully appreciated!
Thanks!
Steve