Gravity_lovr
New Member
Hi,
I have an old farmhouse style two vessel sink in which both drains merge immediately into a cast iron Y fitting that had about 1/2 of broken pipe hanging down. I thought it was a threaded pipe, but after trying to unseize it I found that it was actually all the same piece and was broken off at the base of the taper. There are two bolt anchors, one on either side.
My question is; are there any fittings out there that will make that jump from standard drain pipe to this thing? Your karma is on the line...go!
Thanks in advance,
Patrick
I have an old farmhouse style two vessel sink in which both drains merge immediately into a cast iron Y fitting that had about 1/2 of broken pipe hanging down. I thought it was a threaded pipe, but after trying to unseize it I found that it was actually all the same piece and was broken off at the base of the taper. There are two bolt anchors, one on either side.
My question is; are there any fittings out there that will make that jump from standard drain pipe to this thing? Your karma is on the line...go!
Thanks in advance,
Patrick