zswickliffe
New Member
Hey all, unfortunately I've had some bad luck with a contractor recently and found out he didn't have an actual plumber do the plumbing work which makes me question everything (naturally).
My main question/concern is around whether the drain/vent configuration in this photo is correct. I'm a little worried about the fact that the left sink drain runs past the right sink drain. I don't know a lot about plumbing and I was worried about siphoning essentially. Photo here:
I'm also curious if it's acceptable to have valves with two outlets on the hot and cold water supply with long flex hoses + extensions to reach the left sink? I expected them to plumb copper to the left sink and to have separate shutoffs but other than an increase in failure points on the extensions are there any issues with this?
Thanks so much in advance!
My main question/concern is around whether the drain/vent configuration in this photo is correct. I'm a little worried about the fact that the left sink drain runs past the right sink drain. I don't know a lot about plumbing and I was worried about siphoning essentially. Photo here:
I'm also curious if it's acceptable to have valves with two outlets on the hot and cold water supply with long flex hoses + extensions to reach the left sink? I expected them to plumb copper to the left sink and to have separate shutoffs but other than an increase in failure points on the extensions are there any issues with this?
Thanks so much in advance!