Quick question- I have a 20 gallon pressure tank (entire setup is new, all parts) with a 30/50 switch attached. If I want to raise the pressure post tank can I just set the switch screw to cut off at 40 psi, charge the tank to 38 psi and that will increase my psi post tank? I have a softener after the tank and it seems my faucet pressure has dropped a bit since installing it. I see different switches for sale like 20/40, 30/50, 40/60 are these all basically the same switch just set at factory for each psi ratio setting?
I also have no idea of the GPM of well, bought property and it was already there. I understand about short cycling, if I raise the psi should I just listen to how often the pump cycles to get an idea if the GPM from well pump is good?
I also have no idea of the GPM of well, bought property and it was already there. I understand about short cycling, if I raise the psi should I just listen to how often the pump cycles to get an idea if the GPM from well pump is good?