Jradams76
Member
I was about to install a 2x6 between the studs to mount my wall sink but then discovered what I think is a vent pipe I looked down the wall and it connects to the drain below I turned on the water upstairs and no water runs through it and it’s not above or near any bathrooms can I notch the 2x6 and still use it as a brace or would taking a 1/2” off of it weaken it too much? Another possibility is can I cut the pipe and go through the stud on the left to re route it and come back to it after the brace? Just wanted to see what my options are
thanks
thanks