JWD
Member
I am trying to figure out why the laundry room drains are overflowing at one of the properties where I work. Every time the washer empties, the floor gets flooded. I suspect this has been going on long before I started here as I had to replace most of the studs in the wall from rot.
I had the line snaked to 50feet with no obstruction. I used a scope and saw no issues for 16ft. I've attached a couple photos.
My question: Could the P-trap in the drain line be too close causing the backflow? Any troubleshooting suggestions?
Thanks, much appreciated.
I had the line snaked to 50feet with no obstruction. I used a scope and saw no issues for 16ft. I've attached a couple photos.
My question: Could the P-trap in the drain line be too close causing the backflow? Any troubleshooting suggestions?
Thanks, much appreciated.