PEX repipe - Not happy with the look

[Mikieboyblue]

What’s the box in the wall for the toilets water supply for ?

Yeah, the box facing away on the lower right is the toilet supply with hammer arrestor. The box in the middle at counter height is the ice maker.

I didn't mention it in my last reply but kudos to all the plumbers here who have running pex down to a science.

 

[TomFOhio]

You probably already did it but you should put the steel plates over the water lines where you go through a stud.

 

[Mikieboyblue]

You probably already did it but you should put the steel plates over the water lines where you go through a stud.

Thanks for the feedback. Absolutely. I am doing that as I finish a section! Getting close to having the supply lines done.

 

[Mikieboyblue]

You probably already did it but you should put the steel plates over the water lines where you go through a stud.

Almost ready to pressure test (I need to figure out what I have to buy to test at 100psi).

You guys think I should put one of those huge 10$ nail plates in front) back of the main stack?

It's like the whole wall is nail plates

 

[Twowaxhack]

Fill the system with water. Turn water off and bleed pressure off.

Connect air compressor set to 100psi and pressure it up

 

[Twowaxhack]

If there’s a water heater connected there is a way to pressure it up by using thermal expansion.

 

[Mikieboyblue]

Fill the system with water. Turn water off and bleed pressure off.

Connect air compressor set to 100psi and pressure it up

You just answered part of my new post in the pressure test subject . I apologize for the overlap. I didn't see this reply.