Anyone have a recommendation for a pex expansion tool ?
I’d like to have one just because.
I’d like to have one just because.
Did it work when you used it today ?I've been very happy with my Dewalt 20V expander, but it wasn't cheap. I used it today.
Indeed it did.Did it work when you used it today ?
Does it work without a battery ?Indeed it did.
Not very well.Does it work without a battery ?
Not very well.
I’m thinking a manual expander would last longer. What do you think ?
You might not need a cordless one. I never need much of an excuse to buy new tools.
3-4 seconds is plenty of time for me. I appreciate the post.I will be honest, I am amazed how anyone did Expansion pex with a manual tool and was successful or productive. The thought of doing manual expansions and turns then getting the fitting in seems like hushed effort. Heck the power tool and 1/2 you get 3-4 seconds max before it is almost impossible to get the fitting in before it closes up too much. 3/4 much easier, I can take my time putting the tool down and putting on a 3/4 fitting. I wanted the Dewalt tool, but was out of stock everywhere back in February until May while the Milwaukee was readily available. Depending on how much use I think the Milwaukee is solidly built and will last a along time. You just need to use their grease (as it is potable water safe) and clean the tool and tips after each use. They say the tips should be soaked in degreaser every month when in use, but I have not done that yet and been using tool 2 months.
I agree usually, but in awkward positions with tight for for tool and hands it gets close.
Enter your email address to join: