Jacuzzi Access

[MarianneR]

This isn't really a DIY question but I hope someone can help. I need to get access to the drain on my jacuzzi that's enclosed in marble. How is this going to happen? Do I need to get a marble guy to remove the front panel before I get a plummer or jacuzzi guy? Please help!

 

[Twowaxhack]

Strange place to put the spout. You’d have to reach over the tub to feel the water, or be in the tub.

Get a marble installer to remove it.

 

[breplum]

Why do you need to access the drain?

 

[MarianneR]

I may not need to access it; there's some evidence of a leak somewhere. But I want to know how to do it if I have to at some point

 

[TomFOhio]

If that spout would ever leak on you that whole tub would probably have to be pulled out. Bad design.

 

[SHEPLMBR]

cut a hole in the ceiling below it.

 

[Twowaxhack]

I looked the picture over again.

It should come right out. Just cut around the perimeter and get a small crowbar and pry along the top edge and the bottom edge at the floor.

If it breaks you can get it replaced.

Goodluck

 

[TomFOhio]

cut a hole in the ceiling below it.

I thought about that to but the tub is probably sitting on the wood floor in the back. You would have to cut into the floor blind

 

[Twowaxhack]

She’s on the 22nd floor, probably concrete wiff steel cables in it.

 

[TomFOhio]

I missed that somewhere !!!!!!!

 

[Twowaxhack]

I missed that somewhere !!!!!!!

I read it on a different forum, same post. Forum shopping for answers.