I connected a 1.5 inch PVC pipe to a bathtub drain. The fitting can accept about 3/4 inch of PVC, but I could only insert the PVC about 1/2 inch. I primed and cement both the fitting and the pipe according to instructions and pushed the pipe inside as hard as I could, giving it a quarter turn.
Is my connection good enough? There is a 1/4 inch ridge on the inside that I am worried might trap hair or debris that goes down the tub drain.
I attached a picture of the inside of the pipe so you can see the connection on the inside. I also show a photo of the outside of the pipe.
Is my connection good enough? There is a 1/4 inch ridge on the inside that I am worried might trap hair or debris that goes down the tub drain.
I attached a picture of the inside of the pipe so you can see the connection on the inside. I also show a photo of the outside of the pipe.