Kalen Stickelman
New Member
Morning everyone, hope you are all doing well. Ok so I have a quick question. I just moved a baseboard in my house, and now there is a bunch of air in my lines. I do not have any bleeder valves on any of my baseboards, so I am assuming I will need to do it at the actual boiler.
I drained from the bottom spigot with the red handle, and I did notice some air before I had a constant stream of water. But I think I need to like isolate the zones and bleed that way, just have no idea how to.
Was wondering if anyone can point me in the right direction. I think I need to just shut the zone off at the return end, and just run until air is out. Let me know if this is correct. Thanks everyone.
I drained from the bottom spigot with the red handle, and I did notice some air before I had a constant stream of water. But I think I need to like isolate the zones and bleed that way, just have no idea how to.
Was wondering if anyone can point me in the right direction. I think I need to just shut the zone off at the return end, and just run until air is out. Let me know if this is correct. Thanks everyone.