Hi. Thanks in advance for any advice here.
1) I'm replacing supply pipe with new 200 psi roll pipe. Power wire is 12/3 and should be replaced but have to wait for now. Mostly good, with several splices. Some places showing abrasive wear from torque jerks.
1) I'm using liquid electric tape covered by electric tape to buffer any potential problem spots. This ok for drinking water well?
2) How many torque arrestors should I put on a line that deep?
I already have two, both right above the 1 hp Franklin/Schaefer pump.
3); Have used those little plastic overpriced disks elsewhere in the line. I hate those things. Seem pretty worthless to me.
Any better way to stop wire string from being gradually degraded by torquing ?
Thanks!
1) I'm replacing supply pipe with new 200 psi roll pipe. Power wire is 12/3 and should be replaced but have to wait for now. Mostly good, with several splices. Some places showing abrasive wear from torque jerks.
1) I'm using liquid electric tape covered by electric tape to buffer any potential problem spots. This ok for drinking water well?
2) How many torque arrestors should I put on a line that deep?
I already have two, both right above the 1 hp Franklin/Schaefer pump.
3); Have used those little plastic overpriced disks elsewhere in the line. I hate those things. Seem pretty worthless to me.
Any better way to stop wire string from being gradually degraded by torquing ?
Thanks!