CodeMonkey
New Member
Hi everyone. In the image below you can see where I was planning on connecting a P-Trap at Circle 1 for the washer. I had originally intended to connect it to Circle 2 which is a vent for the septic (fyi, that plug is just sitting there unattached in Circle 2), but I guess I cannot do that and I must drill a brand new hole for the inlet. I still need to vent, however, and I was told by the inspector that I could not vent it to Circle 2 either and that I'd have to connect it higher up the vent pipe. I think that is simply because Circle 2 is lower than Circle 1 where the P-Trap would be. So if I simply drop the P-Trap below Circle 2, can I then connect to it for venting? Or is there another reason I cannot connect there? Thanks!