installing water heater help needed

[roostersgt]

Im trying to replace my home water heater and have run into a new problem. My homes copper pipes coming out of the wall are both 1" diameter. All of my hoses, compression nuts etc.... are 3/4" threaded. I can't seem to locate any 1" compression nuts to 3/4 threaded so I can use the connection lines to water heater. Any ideas???

 

[Twowaxhack]

This would probably be easiest for you

https://www.supplyhouse.com/SharkBi...MIosOs6PDh_QIV-8mUCR3PCggjEAQYIiABEgJBkPD_BwE
I would prefer to solder a 1” female sweat x 3/4” mip adapter onto the copper.

 

[roostersgt]

This would probably be easiest for you

https://www.supplyhouse.com/SharkBi...MIosOs6PDh_QIV-8mUCR3PCggjEAQYIiABEgJBkPD_BwE
I would prefer to solder a 1” female sweat x 3/4” mip adapter onto the copper.

Thank you for the idea. I prefer to use the compression fittings when possible, but have had good luck i the past with shark bite stuff. I hate trying to sweat fittings then going back and trying to redo them when they leak at first test. Just not very good at sweating pipe.

 

[roostersgt]

Thanks again. Just ordered a couple.