Getting new tub spout in correct position.

[JBL]

Replacing a tub spout in a mobile home that was replaced about 15 yrs ago. When pulling divertor knob up, water still partially comes out of the spout.

The plumbing coming out of the wall is 1/2" galv steel threaded pipe and the replacement spout is the same as the I used before.

My problem is I used about 3 wraps of teflon and when I thread the new spout on it works but it feels that it isnt real tight but if I try to spin it another turn, I can only get it about a quarter of the way.

What can I do to get it spun on and in the correct position and be tight.

Thanks for any suggestions

Joe

 

[Mr_David]

Take off the spout. Remove that galvanized steel nipple and replace it with a brass nipple.

If your plumbing system is an all steel pipe system then for go the brass nipple. Replace the nipple with a new galvanized one.

I stick the handle end of my pliers into the spout opening for more leverage.
be careful. To much and you can damage the spout.