Search results

Is there a trick to get a good seal on a NEW mansfeild flush valve seal?

I recently put a heating cord on a hot water line because it bursted when it froze in the attic. There is a GFI real close to where a needed to put it. I tried to look up info on number of fires caused by these cords but cant find any. What have you heard?

Well, this is an apartment building community(10 of them)and they were built 14 years ago in wyoming and these jumpers are in nearly all the units and they placed them right above the water heaters. So, I understand not to remove them but can I relocate them right away within 2-3 min. a foot...

OK so its a ground. SO is there no concern to remove and replace as needed for any length of time?

so I Have a hot and cold copper line with a piece of solid thick copper wire that is fastened to both lines. What is this for?

"They are not suitable for any connection that must be rigid and solid" please explain

I have a hard time trusting the usage of these fittings and I need feedback on everyones experience with them. Can you use them every where?

Since were on the topic, I would run cold water forever and no banging, I would run hot for a little while and no banging, But when I run hot for a long time then tremendous banging would occur. The problem ended up being one loose strap on main cold water line near the water heater. So it would...

could this issue also describe what happens when a clothes washer intermittently draws water during spin cycle and then flutters the pipes in the wall. A bad fill valve in the washer Maybe?

Th This helps me so much, thanks, Now that solves the error code problem. And recently I put on an extension to the intake vent that drops it 8 inches. Is there anything I can do about the freezing air that enters the blower because something is being affected by the cold temperature. Do you...

I had a worn cartridge in a posi temp shower control that had a bad seal and was allowing too much cold and when you used cold water in another sink the hot from the shower siphoned out through the bad seal. This took 3 contractor visits and the notoin that was nothing wrong with water but...

OK ha ha , I was trying to introduce myself in the introductoin section.I got issues with computers, dogs well animals in general, and Direct Power Vents on water heaters as stated on my other post

Bradford White RG2PDV50H6N 50 Gallon, Power Direct Vent Water Heater, Natural Gas

So, the code blinks 7 and a pause (vapor sensor) but its not the sensor. Only happens when 20F or colder, wind is not an issue. The intake and exhaust vents are not iced, so its not blockage. I think it is the Temp Sensor in the blower because the housing is very cold to the touch. My HVAC...

Hey, Folks I am a Maintenance Tech for apartments and I got issues.