Search results

Could be a defective cartridge. The pressure balance mechanism could be failing. Try a new cartridge

Sheplmbr is correct. When u install the valve body without the cartridge it creates a cross connection. The hot and cold water mix to create barely warm water. It's even more noticeable now since its winter and the incoming water is colder. That test plug system only works on new...

if its a moen, its probably the 1248 moen stem

Glad I could help

Yes, this is an American Standard Colony. The screw tends to back out and the cage stays in there. Long needle nose are the best way. Go in and grab the edge and pull hard

Has there been a new sink installed? The drain doesn't look super high in reference to the base of the cabinet. Has a Deeper sink been installed? This would cause an issue making the connections. A shallower sink may resolve problem.

It unscrews counter clockwise. Its a 3 piece handle. The top smooth section, the polished brass accent piece then the handle base.

Its definitely Delta. If its dripping from the spout or shower head, you need the seat and springs, part number RP4993.

I have seen galvanized vent pipe used to cover the hole pretty often. Usually 4 or 5 inch single wall vent pipe wrapped around pipe and covered with dirt.

I "think" its a Grohe faucet. Not totally sure from those pics

Can you show a picture of the stem?

It looks like a Nibco or Streamway stem.