aziandude1
Member
I just recently began renovating the guest bathroom and am stuck with how to properly plumb the diverter value to get the functionality that I want with proper pressure balancing. So what I have is a multi-port Diverter value with 1 input and 4 outputs, with 1 being shared. So far I did the plumbing for the Flow/temp control value and now I need to plumb two body sprays, a tub spout and a shower head. How should I plumb this so that I can have it just output water to (1) only the tub spout (green), to (2) only the shower head (purple), to (3) only the two body sprays(light blue), or to (4) both the shower head and body sprays (purple and light blue). The pipes are 1/2". Attached is what I have so far.
Also wanted to add that each body spray is design for 2.5gpm @ 80 psi while the showerhead is designed for 2.5gpm @ 45-72 psi
Also wanted to add that each body spray is design for 2.5gpm @ 80 psi while the showerhead is designed for 2.5gpm @ 45-72 psi
Last edited: