I got a new bradford white water heater installed by a contractor about 6 months ago. I plan to do my first water heater flush ever. (My previous heater was never flushed and it died after 11 years) I watched some youtube videos on this.
My water heater has a Pilot mode. So I should be fine moving my temperature control to Pilot, then after the flush, moving it up to my desire temperature right?
I don't need to turn off the gas and then re-light the pilot light right? I am just making sure to not make a messy for a seemingly easy job.
Are there some "obvious" details I should pay attention to before attempting to flush the heater?
My water heater has a Pilot mode. So I should be fine moving my temperature control to Pilot, then after the flush, moving it up to my desire temperature right?
I don't need to turn off the gas and then re-light the pilot light right? I am just making sure to not make a messy for a seemingly easy job.
Are there some "obvious" details I should pay attention to before attempting to flush the heater?