Search results

Attached is a photo of the tap. There is no writing on it. There is no diverted, this is just the cold water tap that I have taken off the wall. I took it off the wall months ago and put it all back together. It wasn’t leaking get for a while after that, but it has started again now.

I have a dripping shower. I don’t know if it’s the hot or cold as they are separate taps. Attached are some photos with it in pieces. With this style there doesn’t appear the be a washer that can be replaced. So would I need to replace the whole spindle and tap? Most taps have a thread on the...

What is a wall carriage? After sending photos to someone they have said about $600 to install plus $600 for the toilet. I don’t know if this is a bit excessive

My parents have 3 toilets in there house all the same but are over 50 years old. One of them the bowl is cracked and I have been struggling to get a good seal to stop the cistern leaking. They want to replace the whole thing but I haven’t been able to find a plumber that knows much about these...

I don’t know the brand of the actual cistern, the button says Sydney on it. I have uploaded a picture of the inside I am hoping someone has come across this kind of toilet system. My parents built the house about 50 years ago and they are the original toilets. One of the plumbers that has seen...

I pulled the tap apart, I found a very small hole in the main shaft of the tap (see attached pictures)... Don't know how this has suddenly happened. Does the metal in taps deteriorate over time?? I don't know how much luck I'll have going back to the manufacturer since its 7 years old. I never...

I have bought a new set of o-rings so just need to find time to take the tap fully off. If that doesnt fix it I cant see what else it could be.. the rest is all metal. I posted a link above which shows the tap parts

Here's a link of my tap: http://look.imaxia.com.au/mixers/MBM-C.html From there if you click on Spare Parts.... I have remove parts 1,2,3 and replaced part 4. I wasn't able to remove part 5. I'm hoping I can work from the bottom up to get to the O ring seals (part/s 6)

I've been learning a bit lately cause some things are slowly starting to fail after some wear an tear. My latest issue is my bathroom flick mixer tap. It has a fairly fast drip. I've isolated it to be the hot water side only. If I isolate the hot water tap then the dripping stops. From lots...