Search results

I had 80 people use it at the weekend and it all worked just fine.

http://www.siouxchief.com/Drainage/ResidentialDrainage/Closet-Flanges/Push-Tite.VZ8US I cut out the old closet flange and then installed the one in the above link 888gpm I found the drain line was also on a slant and was able to push it and then screw it and my new flange sat pretty plum...

I had a general read and I have a Push-Tite™ Gasketed Closet Flange 888-GPM just like from your above link and it does not call for cement.

Hi Christoph the old plastic closet flange was not recessed enough it was also at an angle its hard to see from the photo but adding the stainless steel ring on the top caused the toilet to not even sit on the floor. I have cut out the old outer Closet flange and will insert a inter 3" closet...

The flange appears to be connected to the waste pipe... I was hoping there was a gasket so I could remove the old flange level the concrete and insert a new flange.

Thanks for the comment. You might see 3 smaller holes in the flange I had tried to screw in a new metal flange but by doing that the toilet would not even sit on the floor due to the original flange being so high up. I agree about using the plastic shims and caulking, this has worked well in...

My toilet rocked and I found that one of the bolts would not tighten The toilet is on a concrete floor on removing the toilet I found out why it rocked You can see the flange does not sit flush with the floor on one side and it sticks up quite a bit. Because of this one side has...

Just wrapping this up I hope and this is what I have now Tank pressure now set to 65 PSI In terms of a low yield well I was able to pressure wash for about 2 hours the pressure gauge did not drop under about 50 PSI and was able to wash for a very long time. (I wish I could tell how much...

I turned off the power to the pump and then drained my lines I then increased my pressure tank to 38psi to match the new cut in. The pressure gauge I think was at 0 and it took 4min and 28 seconds to get up to 68ps it took 2 minutes to get from about 50 psi to 68 psi. (Would you say that's...

The iron filtration reducing the pressure ? Would be my next point to look at but my wife has commented on how much better the pressure now is.

Hi speedbump, is there a way to tell its max capability , in my fist post I listed my pump info but I don't know what type of pump I have. In terms of water filtration I have a iron removal tank and then a bio light

What would you be testing for speed bump ? I just had 2 snake oil sales people tell me my water "might" have heavy metals in it yet when I moved in the bank did a water test and said there was no issue.

Thanks VM I have read your very helpful info about check values on your website The shower is running much better now at 40/68 but my guess is the pressure tank is still set to 28 psi to be 2 psi under the old cut in setting. As my pump seemed to run for a while to make it up to 70psi hence...

Thanks Johnjh20 sorry I don't want to open the can of worms about check values about how many you should have or should not have lets just hope that I have one that is at least working for now, I am new to pumps and wells so I guess I chucked that out there as it was just a uneducated...

My house seems to have quite low water pressure its large in size and I was never sure if that was the real reason why we have low water pressure. The shower being my wife's my gripe even with no shower head the shower in our main bathroom was pretty poor in terms of flowing and even with the...