Search results

Meh...........

I think you should use something with a bearing to allow it to.spin easily

I clearly disagree..I've yet to have a problem lifting a bowl set in plaster and I don't know where plumbing is done that there's no flange and johnibolts...all you have to do is wiggle the.bowl side to side and up she goes..its not a matter of changing....its doing the right job and if your...

Your really arguing that plasters not the way to set a bowl...to each their own...I've set many bowls...if your flange is the right height and you set it correctly...clean the smushed out plaster....you have a professional look and a bowl that will not rock...I've seen so many silicone jobs that...

Its been done that way for yrs...its the way I was taught by an old school guy

Provide a pic

By a general hand snake

Get rid of the damn wax gasket with the horn...get a stack n seal or two raise the height and reset the modular rough in

I highly doubt that's code you would be wet venting your tub

Don't buy a new toilet which is unnecessary. Auger the bowl if still an issue, pull bowl and send auger from the horn ( bottom) up

Use a drill style snake and send it in reverse BC a lot of times you wind up going up the vent instead of down the drain

Use a regular depth wax ring without the cone...if flange is too low and can't be fixed try stack n seal extensions to bring height up

You just need the vacuum breaker unless the tailpiece is in bad shape

Try.running a toilet auger through the bowl...no luck then inspect main sewer but if there's a stoppage in main line it will show up at lowest point ie. Shower or tub

You need a fill valve as the other member stated

You need a wye and 1/8th bend

Definitely a venting issue

Set the bowl in plaster will never move and looks professional