Search results

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Plumbero007

    Marketing Your Local Business

    I just run google search for: Lake County, Florida plumber Where are you.....??? For now forget about social marketing, firs fix that gaping hole. Get a website you can update yourself, dead static and boring website will not do. For tradesmen who is not network savvy try this link...
  2. Plumbero007

    add subfloor in basement bathroom

    I'm assuming that you got 4" cast iron stub-out currently flush with concrete slab. Measure distance of top of the rubber gasket to bottom of your toilet flange. if you have 2" there you will be fine. After you finish your new floor, bolt your flange TIGHT to finished subfloor then tighten small...
  3. Plumbero007

    Washer and Sink drain

    Is a kitchen drain vented?. Check the roof above kitchen sink. If you have window above kitchen sink there should be a vertical vent pipe on ether side of the window. If the sink is vented, run 1 11/2 or 2" if posible to 2" "Y". Remove old bucket trap from washing machine and instal new...
  4. Plumbero007

    Washer and Sink drain

    any pictures?. it would help. Washing machine needs its own, separate trap. Where is the vent for all this?
  5. Plumbero007

    Tub faucet brand?

    American Standard will do nicely. Looks like you have gone dip enough, so you can install whatever mom likes.
  6. Plumbero007

    Custom shower - water lines after valve

    what is your pump well pressure, at start of cycle and end of pumping cycle?. to run 3 heads you will need at list 55 psi
  7. Plumbero007

    Does this look okay??

    remove Vertical nipple and L-bow. replace L-bow with "T" with extra opening pointing down. Screw 4" nipple pointing down and cap it. When you at this increase length of this vertical nipple by about 1/4" to make horizontal pipe with cut-off valve level. THIS IS GREAT JOB, neat and clean...
  8. Plumbero007

    Bringing new supply line up through existing slab

    You can drill from inside of the garage at angle, so your drill bit comes on outside bellow ground level, dig hole outside to fond end of your bit. Keep in mind that depends on your location section of the pipe on outside should be deep enough to prevent freezing. PEX will do fine in concrete...
  9. Plumbero007

    Is this for the city or us?

    Water meter valve on street side with padlock holes belongs to the city and should be the City's responsibility. As mr_Dave above responded if that valve is not working City should fix it. After that you be able to turn working valve off and see if meter is moving. If so, hunt for leaks on your...
  10. Plumbero007

    Help removing tub/shower stem cover

    Looks like somebody in the past inserted sleeves before tile job was completed. Use small chisel or old screwdriver to chip mortar around sleeves, then try to unscrew them. This old faucet should be replaced. Just changing stems my not work for long. You will have to unscrew those stems and...
Back
Top