Search results

Also, how much "play" is acceptable in CPVC? I have an area where the pipe comes out of the wall (shown in picture) and runs parallel perpendicular with the wall about 2 inches from it. I need to run it along the wall to get it behind my furnace. If I turn the 45 in slightly towards the wall...

What's your experiance with PEX pipe? I just discovered it the other day and think it may be good for this application. How are the joints with CPVC and brass made? Are they simple?

Right, same questions though.

Thanks. Here's what I'm working with. The water supply comes up from the bottom right (behind drywall), comes out of the wall, goes through a shut off valve and the pressure regulator (just below were picture cuts off), reenters the wall, turns left through a 2X4 and Ts. The up T is to the...

I'm installing a new water softener. I have a very small area to tie in to the water line between the pressure regulator and the T that goes to the water heater. The pipes are in the wall and I need to run them out of the wall. This will require a lot of elbows. There is one area I'm going to...

Thanks for the reply. It's electric. Do you have any thought on the 10 foot rule?

I bought a new softener to install in my house. There has not been a softener before so this is a new install. After reading the manual and researching online I'm fairly confident in my ability to install the softener. The positioning of the pipes after the pressure regulator is very...