Search results

I have a heat pump electric water heater with 65psi and 50 gallon water heater. What size do I need as several people all told me difference sizes? Thanks

Can I put XPS foam, the pink stuff 2" under my water heater to raise it off the ground and help it insualte better from the cold concrete floor? Will the xps foam want to shrink or sink after a long time? Thanks

I have public water with a new house with a meter pit. Water line is about 300 feet long. I ran a 1" pex line from the main over to my pex manifold. I tested the psi in the house and it is at 85psi. Is this anything to worry about? I do like have good pressure when washing hands but some people...

I got everything set up and it seems to held 5psi for about 15 to 20 min then it dropped 1 to 1.5 psi after 30 mins. Should I worry about this at all or is it fine since it did not drop in the first 15 minutes? Thanks

Is this required? I am building a new home and live in PA. Thanks

I have a 1570sqft ranch house new construction and have 2 full baths, kitchen sink and laundry room washer and sink. I have some 2" vents and 1.5" vents and the run from the start of the vent to the top of the roof will be around 45 feet. Can I tie them all together in the attic and avoid...

Hello I am roughing in a drain in new construction and its about a 38 foot run of 2" pipe just for the laundry room washer and sink in the laundry room. I only can get about 4 inches of pitch/slope in the run. Do you think only have a .1/8th or .15 inch per foot of pitch is ok for a 2" pipe? I...

Hello, I have public water and 1" line stubbed in the foundation. It is new construction. Should I run a 3/4" or 1" pex line to the manifold? The manifold supply lines are all 1/2" and each fixture will be on its own home run. Would I get any benefit or better water pressure if I run a 1" line...