Search results

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. X

    Pipe Clamps: Seeking the supplier.....

    Hi All, I have a pipe installation project in progress but have been stymied by (so far) being unable to find the supplier of a particular pipe saddle clamp for which I have the picture: 09c79d82ef by xylstra posted Oct 22, 2019 at 11:50 PM The particular clamp in question is the...
  2. 09c79d82ef

    09c79d82ef

    Pipe Saddle Clamp.
  3. X

    Ejector-Head- Incredible Product Defect......

    H Hi Cary, Thanks for the invite-in but I've got too many other issues on the go at the moment but I'll give you with some useful ammunition to broaden the debate: Inverter-Drive Heat-Pumps. These are marketed and sold on the lie that they will lower your energy costs .... so...
  4. X

    Ejector-Head- Incredible Product Defect......

    Hi 'Valveman', That's not the only thing they don't tell you about VFD's , in fact, many of the buyers don't even try to educate themselves about some important technical issues ..... quite a few make the fatal error of retrofitting VFD's to old or non-compatible...
  5. X

    Ejector-Head- Incredible Product Defect......

    Hi Valveman, Understood. The use of rigid pipe is peculiar to America and similar latitudes, I suspect due to the seasonal prevalence of ice and frost, code compliance issues and traditional practice. In Australasia (I'm in New Zealand) this practice is unheard of. All...
  6. X

    Ejector-Head- Incredible Product Defect......

    Hi 'Valveman'. Thanks for the reply. I need to clarify that I already know all the solutions and work-arounds (I am an engineer). Seeking solutions was not the purpose of my post. The point is that the kit was flawed new from the box. There are legal issues of liability for putting the matter...
  7. X

    Ejector-Head- Incredible Product Defect......

    Ejector-Head for Jet-Lift Deep-Well Pump - Wrong Connector Pipe "The Connector-Pipe's the wrong length @##%$**!!!" .... Can anyone relate to this? (I want to hear your story)...... The attachments below illustrate a (brand-new, fresh out-of-the-box!) 'TAIFU' (Chinese brand) ejector-head in the...
  8. X

    JET-PUMP Installation

    Hi Valveman, Thanks for your encouraging advice. In hindsight, I realsised that two priming ports required for an inlet check-valve was never going to be a go-er so will only install it on the pump outlet. I'm pulling the existing submersible out (it's a sledgehammer to crack a nut and...
  9. X

    JET-PUMP Installation

    Hello, I'm after advice from professional Water-Well pump installers. Have a look at the attached diagram illustrating my Well installation. I am intending to install a 900W (~1-1/5Hp) Jet-Pump with a fully immersed Foot-Valve at a depth of ~ 5-6m (I'm roughly at sea-level). My concern is the...
Back
Top