Search results

Finally looked in the book. Yes rod is Magnesium. Looking now to see if there are options for aluminum anode. Book does not mention the option. It is a small 4.5 gallon Bosch unit. I will get back to you.

Finally looked in the book. Yes rod is Magnesium. Looking now to see if there are options for aluminum anode. Book does not mention the option. It is a small 4.5 gallon Bosch unit. I will get back to you.

Got ya. Let me investigate the type of anode it came with. Yes the water is cloudy when just out of faucet and it clears up in about 20 seconds.

Yes. But where does the air come from? Certainly air cannot get into the pressurized line. Is the water heater squeezing air out of the water????

Yes. But where does the air come from? Certainly air cannot get into the pressurized line. Is the water heater squeezing air out of the water????

I have a shop building located approx. 200' from my well with submersible pump. Water treatment is located immediately next to well. House is also about 200' from well. I have a sink in shop that has worked fine until I installed a small point of use tank water heater. Now every time I turn...

I am not a plumber so can't help with the plumbing. I am an electrical contractor. Make sure you check electrical requirements for the tankless unit. The tankless will likely use a much larger circuit which will force you to add a new larger 220 volt circuit for it. They use larger...

They replaced with copper at my request. Works perfectly now.

So why do you suspect they didn't?. Surely they know they should do so and I can't imagine it's a cost issue. Is there any issue with sweating copper in this tight space or this close to valve?

I am building a home and my plumber recently finished installing the trims in the tub/shower. Water was coming from the shower head when it should have been tub spout only. I've read the threads that a restriction causes this. If my picture is visible (picture was taken many months ago...

Thanks for the replies. I am going to pressurize the system before drywall so I can be 100% sure all is well.

Frodo, during electrical rough in the plumbing stub outs had been bumped as people walked by them. The stubs will turn on the 90 degree crimp fitting at the wall. Not easy to turn but I noticed one had been turned about 45 degrees so I spun it back to 90 degrees. Should I be concerned about...

I am an owner and builder of a new concrete block home in Florida. The plumbing is being done by a local sub. I am using a manabloc and pex. I like the home run system of the manabloc. The picture shown is the rough in under the kitchen sink. My non professional plumbing opinion is that...