Search results

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. G

    Faucet identification help

    It looks like a Moen product, but I don't know for sure. Your best bet is to call Moen Customer Service and they can help you. They will give you a number to txt the picture or email address or anyway you want to. They can tell you if it is a Moen product and if not they might tell you who else...
  2. G

    Problem with Hot Water Circulator Pump

    Ya your right. What do you think of the heat trap idea?
  3. G

    Problem with Hot Water Circulator Pump

    Sounded like he said that the pump was the lowest part of the system and I didn't see any part that said he has a slab
  4. G

    Problem with Hot Water Circulator Pump

    About a 12" drop and then back up to your fixtures. It would stop gravity circulation when the pump is not runnung
  5. G

    Problem with Hot Water Circulator Pump

    I would say at least a 12" hot water p-trap. That should stop circulation when the pump is not running
  6. G

    Problem with Hot Water Circulator Pump

    Or better yet, instead of Installing a motorized valve, install a heat trap on the hot water supply out of the water heater. Basically a upside down p-trap made of the water piping that you have. I would pipe back down and then back up to the fixtures
  7. G

    Problem with Hot Water Circulator Pump

    Maybe just Installing a power operated control valve to open and close at certain times of the day?
  8. G

    Planning to correct venting issues

    You can wet vent a bathroom group with the lav. I don't understand the kitchen. It looks like the vent is tied to the inlet side of the p-trap. If the vent was tied downstream of the kitchen p-trap then its fine
  9. G

    Merry Christmas

    Marry Christmas Frodo, and everybody
  10. G

    Problem with Hot Water Circulator Pump

    Sounds like you don even need a pump, because you have enough gravity to let it circulate by itself
  11. G

    Low shower pressure

    Now I know to use CLRnext time I come to that situation. Thank you
  12. G

    Relocate Dirty arm into wall??

    You should be fine without the dishwasher
  13. G

    Relocate Dirty arm into wall??

    I feel bad. I was thinking dishwasher
  14. G

    Low shower pressure

    Maybe but I don't know what's clogging the port. Maybe a chunk of rubber or something
  15. G

    Relocate Dirty arm into wall??

    Not only it is ipc code but I would recommend it any way, just so you don't have to cable the line as much, since you want to install a garbage disposal. Is that 2" abs below the tee? I you have slack in the vent stack then you can glue couplings but not a big deal if you can't. Furncos work...
  16. G

    Low shower pressure

    I have been in your situation I cut the riser right above the shower valve and I was able to blow through to the shower head, but not down to the shower valve, with the cartridge removed. I used compressed air. The reason the customer called was because there wasn't water coming out of the...
Back
Top