I can see one on the cold side and it looks like he ran a screw through the one on the hot side along with the galvanized strap. The guy had no...
There are brass tabs on the valve body with tappings for the two screws that hold the plate in place.
Post a picture of the drain lines under your sink.
The problem is the hole in the enclosure needs to be inlarged. It should be the same size as the plastic plate that came with the valve body.
What is that 2" line behind the shower drain?
The flush valve is the same as glassier bay's.
Looks like the glassier bay toilet.
It should be on the bottom of the heater. Call the manufacture as the location varies.
Have you checked the air filter on the heater?
There two different systems. Yours is a heating system that operates on a much lower pressure .
12-15 # With a relief that opens at 30#
There shouldn't be a valve between the heater and the thermal expansion tank.
T Tape is not needed.
You may be OK. The threads don't seal the joint. There is a washer in the hose connection that seals against face of the hose bib.
That I have done. This is the only site I'm having problems with.
I'm an old returning member, this site was never this slow. What happened?
What type water heater do you have? Is it a tankless heater?
Separate names with a comma.