Recent Activity

Activity stream for all registered members at Plumbing Forums - Professional & DIY Plumbing Forum .

Help Support Plumbing Forums by donating:

  1. Diehard replied to the thread Home Water Pressure Reduced After Changing Pipes.

    Question 1 - Not having the hot water connected would not cause the cold water pressure to be reduced. Question 2 - No! I would suggest...

    Jun 25, 2019 at 2:29 PM
  2. thibs attached a file to the thread Moen faucet dripping.

    Hi there, Just wanted to post an update. The back of the shower is not in a high traffic area so I left the wall open to see what...

    faucet.jpg faucet.jpg Jun 25, 2019 at 2:16 PM
  3. FishScreener replied to the thread Acceptable wet vent??.

    The dishwasher needs to go up, to an air break, before it goes down to the garbage grinder. I like the deck mount air breaks, because...

    Jun 25, 2019 at 2:12 PM
  4. Skot pearson replied to the thread Acceptable wet vent??.

    The dishwasher drains into the disposal. I would be tying the clothes washer below the kitchen sink/dishwasher inlet and above the...

    Jun 25, 2019 at 11:15 AM
  5. splatty2000 posted a new thread.

    Home Water Pressure Reduced After Changing Pipes

    Hello, I have recently replaced the pipes in my VERY small home. I cut the line just after the water meter and line that runs to the...

    Forum: General Plumbing Help

    Jun 25, 2019 at 12:57 AM
  6. ddahlgren replied to the thread Change Moen faucet cartridge.

    The video offerd worked quite well and very happy with the results no drips works as it did 15 years ago and have parts for the cold...

    Jun 25, 2019 at 12:42 AM
  7. PeteM attached a file to the thread Replacing Water Heater - Water Lines.

    Would it be ok to use this?..... [ATTACH]

    IMG_0727.jpg Jun 25, 2019 at 12:37 AM
  8. FishScreener replied to the thread What valve do I have??.

    It looks like a Moen to me.

    Jun 25, 2019 at 12:17 AM
  9. FishScreener replied to the thread Replacing Water Heater - Water Lines.

    Get the sharkbite, disconnector, and take the shark bites off. Where the upper shark bites are located, install the shark bite adapter...

    Jun 25, 2019 at 12:15 AM
  10. FishScreener replied to the thread Change Moen faucet cartridge.

    Fill the housing with white vinegar, and let it set for a while. Screw a longer screw in to cartridge that gets the screw head above...

    Jun 25, 2019 at 12:02 AM
  11. FishScreener replied to the thread Need help indentifying.

    Take it to a good hardware store, and they can match it.

    Jun 24, 2019 at 11:57 PM
  12. specgrade liked jeffmattero76's post in the thread Broken Tub Drain.

    Try using just the blade from a hacksaw. Saw thru the strainer, being careful not to go all the way through. When you get close, use a...

    Jun 24, 2019 at 11:07 PM
  13. Fire404 posted a new thread.

    Shower handle stuck

    I think I already might know the answer to this one but I shocked my well and think I clogged my cartridge (no flow of hot water from...

    8CBE5C1E-F9F4-4239-8235-B998AA9753C3.jpeg 8FCB0F53-454C-4579-8FDB-359385BA3F0B.jpeg CC21C605-9F9B-4C2E-A4EC-A8685748F27D.jpeg

    Forum: General Plumbing Help

    Jun 24, 2019 at 10:19 PM
  14. bobbobobbo replied to the thread Carbon Monoxide from gas dryer. Concern? Science.

    Thank you. This run is 40 feet with 4 bends... goes from 4" to 5" for 80% of the run. It's how the townhomes installed them. The room...

    Jun 24, 2019 at 7:46 PM
  15. PlumbGate replied to the thread Leak through Ceiling -- Looking for Advice.

    I had a similar issue and it ended up being the seal between the tub and the tile. I re-caulked it and the leak stopped. It was...

    Jun 24, 2019 at 7:38 PM
Loading...