can one of you ID these 2 faucets ??

Advertise with us
Shop deals on ebay
shop deals on amazon
Support your community
Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
J

Jim Jensen

Well-Known Member
Joined
Feb 1, 2019
Messages
143
Reaction score
47
Location
Jacksonville, FL
the bath one is marked DELTA on the bottom

the kitchen one, I think is a Delta, but I couldn't see any writing on it anywhere.

the bath one leaks when you turn it on fully, the kitchen one is just dripping, if you don't have it pushed down, "just right"....

Just want to see if anyone can tell me what cartridge / part I need to fix each ??

BATH:

upload_2019-5-23_11-22-41.jpeg



mstr bath faucet

mstr bath faucet


Kitchen: 20190523_074051.jpg


THANKS to you all !!!! I have been following your forum, for a few months, just working on an old 1960 house that my mother purchased, last year, here in Jacksonville, FL.
 
These both appear to be Delta (vanity of course) and probably use the same repair kit (new ball and new seals and springs). Not really a Delta guy, Moen usually.
There are a couple good "How-to" videos on YouTube on how to go about rebuilding them. Just search for "rebuilding Delta faucet"
 
delta faucets are simple loosen the allen set screw on the handle...remove the handle this exposes the ball under a round chrome cap some have flat sides remove that there are 2 black caps and under them are 2 springs replace those while that is apart wiggle the spout body left to right with upward pressure there will be 2 o rings rplace them
if there is a spray hose the divereter is between the o rings grease the orings the inside of the spout body wiggle it back on when you put the ball back on it has a little tit thagoes into a slot on the body....the plastic piece that goes over the ball also has a tit that fits into the faucet body...thread the chrome piece on and re installte handle
 
Geofd said:
delta faucets are simple loosen the allen set screw on the handle...remove the handle this exposes the ball under a round chrome cap some have flat sides remove that there are 2 black caps and under them are 2 springs replace those while that is apart wiggle the spout body left to right with upward pressure there will be 2 o rings rplace them
if there is a spray hose the divereter is between the o rings grease the orings the inside of the spout body wiggle it back on when you put the ball back on it has a little tit thagoes into a slot on the body....the plastic piece that goes over the ball also has a tit that fits into the faucet body...thread the chrome piece on and re installte handle
Click to expand...
buy only delta parts
 
You must log in or register to reply here.

Latest posts

Back
Top