That drain fitting is probably sized for pvc/abs/cast iron. The OD of copper is smaller so they tried to seal it with epoxy or resin.
Sounds like you need a general contractor
Replace the pressure balance cartridge
It’s IKEA crap for their floating vanity
You should’ve flushed the supply line. Now you have to take off the top of the fill valve and flush out the debris
Stick some needle nose pliers in the crosshairs of the strainer to keep it from turning while you’re tightening the nut
Looks like a Lowe’s POS for $100. You’re better off buying a new faucet
What happens in the winter time when a/c isn’t running and the trap dries out? Sewer gas gets pulled into the airstream whenever the heat is on....
[ATTACH] Your push button flush rods are too long. Adjust them according to the instructions.
yes, that is the service kit
Those are service kits, you can also see the installer used pvc on t+p drain on the left. Right side pvc is condensation drain.
The service kit is installed on the unit, I can see it in the picture
A water leak detector is typically for pressure leaks.
You need a camera w/ sonde and a locator to find the drain pipe
You need a branch tailpiece
Did you tile the floor? If so and there wasn’t tile before, your toilet flange is probably too low and you’re not getting a proper seal. We see...
Separate names with a comma.