NO. What is that 90 at the back end of your green arrow on the back end of the wye fitting? looks like its going down
Just goes to show that old dawgs can still learn new tricks. I have never seen left handed drill bits.
We have a left hand thread 2 - 1/2' pipe...
They have a cheap version of a nipple extractor for landscapers to remove plastic nipples.
They are usually a tapered aluminum extractor and don't...
Like this one
1/2" compression. Not a vey common size. Sometimes wrongly called out.
The tubing would be 1/2" OD and not confused with 5/8 tube which is often...
That's a tough one to read. Presuming the tank filled before he flushed it, or did it fill at all.
Wrong flapper maybe not closing.
I agree. With today’s ultra low flow toilets you get less water to carry [emoji90] down the tube. Use 3” and will carry waste a bit farther
I have seen that type of deterioration in copper tube as well on both hot and cold piping. Had a house that only the H & C horizontal runs in...
You’re probably right about tightening from top. That pin/rod next the shoe probably stops the rotation of the shoe as you tighten from top....
Maybe look for a toilet that has a built in ejector system.
Damn! I was probably still playing with tinker toys & little plastic soldiers in ‘63
cement is the bonding agent in concrete.
You mix cement with sand to make mortar and sand and gravel to make concrete.
If you don't put down a...
Zane you're to nice. You Have friends of friend's friends ;)
What's that old saying? Friends in need are friends indeed.
You should run for...
Look for one of these
American Standard 047242-0020A
Trip Lever for use with 4072 and 4010 tanks
Separate names with a comma.