Diehard's Recent Activity

Help Support Plumbing Forums by donating:

  1. Diehard replied to the thread Possible pressure switch issue?.

    When/if you do move it up to the cabin level, be sure to readjust that pressure switch(lower) to reflect the new elevation. Otherwise...

    Nov 12, 2019 at 7:30 PM
  2. Diehard replied to the thread which island sink vent design meets code?.

    Well Maryland plumbing code does not use the UPC. I believe Maryland adopted the National Standard Plumbing Code. Neither sketch 2 or...

    Nov 12, 2019 at 7:04 PM
  3. Diehard replied to the thread Condensate filters.

    There are but for other types of condensates....

    Nov 12, 2019 at 3:44 PM
  4. Diehard replied to the thread Sump Pump Help.

    Well I don't believe a 1 HP motor is large enough to be concerned with starts per hour. Plus being a submersed application I believe...

    Nov 12, 2019 at 3:36 PM
  5. Diehard replied to the thread Sump Pump Help.

    You guys are going off on a tangent, I believe. Once the discharge flow has no more resistance, as in a gravity flow, it has no effect...

    Nov 12, 2019 at 4:26 AM
  6. Diehard replied to the thread Sump Pump Help.

    Sunho... Not sure what you are trying to accomplish. Are you trying to reduce the starts per hour?(That's typically the concern for...

    Nov 12, 2019 at 4:20 AM
  7. Diehard replied to the thread Sump Pump Help.

    Jeff... He bought a replacement pump already and reduced it to "down to 2 minutes ever 4 minutes." That's not bad. That's 10 starts per...

    Nov 12, 2019 at 4:13 AM
  8. Diehard replied to the thread What could this PVC tube be running over septic tank?.

    The thought crossed my mind. We never know.

    Nov 12, 2019 at 3:16 AM
  9. Diehard replied to the thread Sump Pump Help.

    The recycle time as well as your run time would of course vary based on your pump size. But those two times also vary based on the...

    Nov 12, 2019 at 3:14 AM
  10. Diehard replied to the thread What could this PVC tube be running over septic tank?.

    What size is it? Do you have an idea which way your water service line runs? I would be inclined to reroute the line once I found out...

    Nov 11, 2019 at 10:20 PM
  11. Diehard replied to the thread Possible pressure switch issue?.

    When you adjust the air pressure in your tank, make sure there's no water pressure on it. Google it if you are not familiar with the...

    Nov 11, 2019 at 9:18 PM
  12. Diehard replied to the thread Possible pressure switch issue?.

    Glad to hear it. Now, if you're curious, check you pressure in the cabin(of course it will fluctuate by approx. 20 psi since that what...

    Nov 11, 2019 at 9:04 PM
  13. Diehard liked Kenyon's post in the thread Possible pressure switch issue?.

    The tank pressure was at 65 PSI when it was shutting off before. Now I have it adjusted so that it shits off at 85 PSI and kicks on at...

    Nov 11, 2019 at 9:01 PM
  14. Diehard replied to the thread Possible pressure switch issue?.

    @FishScreener ...I'm curious as to where/how you came up with the 0.1 gpm.

    Nov 11, 2019 at 9:00 PM
  15. Diehard attached a file to the thread Capping off an ABS drain connector 2 1/4" OD.

    I thought the link I had shown had the reaming bit for about $13. Out of curiosity, where is that "P3003.9.1 Mechanical joints" taken...

    Mech Joint1.png Nov 11, 2019 at 1:34 PM