Mikieboyblue
Well-Known Member
Hello folks!
I would like feedback on a DWV redesign with a focus on code compliance and "do-ablity."
I feel like I will have trouble keeping the sink drain below 24" on the washer side. I wish the main stack drain was lower. It would be a good amount of work to pull that all, cut new holes in the studs and sister over the original holes.
Of note, all copper in this diagram will be repiped with PEX (probably B because that is what I have).
Later I will have an inquiry on dealing with a removal of a valve on the water main coming up from the slab.
Thank you in advance!
Mike
Large version: https://i.ibb.co/Fh29JyZ/DWV-20210829.png
I would like feedback on a DWV redesign with a focus on code compliance and "do-ablity."
I feel like I will have trouble keeping the sink drain below 24" on the washer side. I wish the main stack drain was lower. It would be a good amount of work to pull that all, cut new holes in the studs and sister over the original holes.
Of note, all copper in this diagram will be repiped with PEX (probably B because that is what I have).
Later I will have an inquiry on dealing with a removal of a valve on the water main coming up from the slab.
Thank you in advance!
Mike
Large version: https://i.ibb.co/Fh29JyZ/DWV-20210829.png
Last edited: