thriftyhiker

LATEST ACTIVITY

• Posted in thread: Elbow Placement on 01-23-2012 at 12:04 PM
  Also, how much "play" is acceptable in CPVC? I have an area where the pipe comes out of the
  wall (shown in picture) and runs parallel perpendicular with the wall about 2 inches from it. I
  need to run ...

• Posted in thread: Elbow Placement on 01-23-2012 at 11:59 AM
  What's your experiance with PEX pipe? I just discovered it the other day and think it may be
  good for this application. How are the joints with CPVC and brass made? Are they simple?

• Posted in thread: Elbow Placement on 01-16-2012 at 08:07 PM
  Right, same questions though.

• Posted in thread: Elbow Placement on 01-16-2012 at 07:22 PM
  Here's what I'm working with. The water supply comes up from the bottom right (behind
  drywall), comes out of the wall, goes through a shut off valve and the pressure regulator (just
  below were pictu...

• 

  Added a new Photo on 01/16/2012

• Posted in thread: Elbow Placement on 01-16-2012 at 06:17 PM
  I'm installing a new water softener. I have a very small area to tie in to the water line
  between the pressure regulator and the T that goes to the water heater. The pipes are in the
  wall and I need t...

• Posted in thread: Softener/Pressure Regulator Positioning on 01-09-2012 at 09:04 PM
  Thanks for the reply. It's electric.Do you have any thought on the 10 foot rule?

• Posted in thread: Softener/Pressure Regulator Positioning on 01-09-2012 at 06:35 PM
  I bought a new softener to install in my house. There has not been a softener before so this is
  a new install. After reading the manual and researching online I'm fairly confident in my
  ability to ins...