VIEW MY

johnjh2o

Gift Premium Subscription To johnjh2o

Join Date:

07-21-2011

Last Activity:

07-28-2014 9:25 PM

Likes Given: 255

403 Likes on 321 Posts 

LATEST ACTIVITY

  • Posted in thread: New bath plumbing and faucets, low water pressure on 07-29-2014 at 02:00 AM
    You need to replace the cartridge. That is a Moen balance pressure faucet. If they set for a
    long time without use the balancing spool becomes frozen. Call Moen they will send you one free
    of charge.

  • Posted in thread: How to ID Polybutylene pipe? on 07-29-2014 at 12:54 AM
    If it's gray there is a good chance it's PB pipe. If you had a house inspection they should
    have told you what type pipe you have.

  • Posted in thread: How do I turn on the shower? on 07-28-2014 at 11:28 AM
    I was thinking the same thing when I saw the post. I never installed a setup like that but I
    have repaired a few.

  • Posted in thread: How do I turn on the shower? on 07-24-2014 at 04:05 PM
    My guess is it's a Delta spout. You need to pull down on the lower section of the spout.

  • Posted in thread: rust on gas pipe threads on 07-24-2014 at 11:55 AM
    I would be more concerned with the open line not being caped. Depending on just the gas valve
    is a bad idea. . 2nd is the bushing. Bushings are not allowed on gas lines it should be
    replaced with a re...

  • Posted in thread: Hello Guys!! on 07-23-2014 at 09:44 PM
    It's great to have a moderator that stays on top of these spammers.

  • Posted in thread: How do I get this drain apart? on 07-22-2014 at 09:42 PM
    John, you should check out the new technology of ungluing PVC, CPVC, and ABS joints using new
    products called pipe debonders. See it at xxxxxxxxxxxxxxxx. It is pretty exciting to unglue 12
    inch, sched...

  • Posted in thread: [PEX] Full Re-Plum on 07-17-2014 at 04:53 PM
    Working in the space they had fittings were the way to do it.

  • Posted in thread: Remove old strainer and plumber's putty without breaking ceramic sink on 07-17-2014 at 03:40 PM
    It should be no problem. Plumbers putty doesn't get hard.

  • Posted in thread: asking the pros on 07-17-2014 at 03:38 PM
    If all is OK the water level in the tank should be just at the height of the bottom of the exit
    line.

FORUM SIGNATURE
John
1 COMMENTS
Posted: 
June 18, 2013  •  09:47 AM
I'm afraid I don't know what faucet I have.
 
POST A COMMENT