SnakeOut

Gift Premium Subscription To SnakeOut

Join Date:

07-04-2014

Last Activity:

07-06-2015 12:43 AM

Likes Given: 1

LATEST ACTIVITY

  • Posted in thread: Dishwasher leaking on 07-06-2015 at 04:21 PM
    make and model of dishwasherget a water inlet valvethe bottom panel,undr the door, remove
    it.look under it, where the water hooks up, that is the inlet valve.turn off
    water/disconnect/remove water l...

  • Posted in thread: Dishwasher leaking on 07-06-2015 at 12:43 AM
    hello snake out.since you only wash your dish;s once a mth [that does not sound right] change
    out the valve under the sink..i say this because of infrequent use for your reply frodo. The
    thing with r...

  • Posted in thread: Dishwasher leaking on 07-04-2015 at 07:56 PM
    Hello,I have a Maytag dishwasher model MDB4409PAW0 which I don't really use. It slowly leaks
    water into the unit, presumably from the hot water source. It will fill up and start leaking
    out onto the f...

  • Posted in thread: Pressure Regulator Install Help on 07-06-2014 at 06:38 AM
    Ok guys,Here is the Frankenstein job that I created (dry assembled) that connects that stupid
    regulator to my cold water supply.Right side: To Reverse Osmosis Unit.Left Side: To kitchen
    faucet.Bottom:...

  • Added a new Photo on 07/06/2014

  • Posted in thread: Pressure Regulator Install Help on 07-04-2014 at 09:53 PM
    No, you only need to solder a male adapter on one end, the other end you can attach to the
    supply stop valve via a compression connection.Gotcha, thanks.

  • Posted in thread: Pressure Regulator Install Help on 07-04-2014 at 09:51 PM
    There is a stop made with both 3/8" O.D. x 1/4" O.D. compression nuts. That's what you need.Hi
    johnjh2o,I actually had that part, the 3/8 - 1/4 stop, in my hand. The problem is that 1/4" OD
    is not the...

  • Posted in thread: Pressure Regulator Install Help on 07-04-2014 at 09:40 PM
    A short piece of 1/4" copper (3/8" OD) with a 1/4" male adapter soldered onto the end of
    it.Hello phishfood,If I understand your post, you are suggesting to use 1/4 copper tubing, and
    solder slip fitt...

  • Posted in thread: Pressure Regulator Install Help on 07-04-2014 at 03:13 AM
    Hello,I need a suggestion on how to connect a water pressure regulator to my tap water source.
    The pressure regulator has an odd type fitting that doesn't match up to my water source. (see
    photo #1).D...

  • Added a new Photo on 07/04/2014

0 COMMENTS
POST A COMMENT

Newest Threads

LATEST SPONSOR DEALS