Plumbero007

LATEST ACTIVITY

• Posted in thread: Marketing Your Local Business on 05-05-2012 at 03:40 PM
  I just run google search for:Lake County, Florida plumberWhere are you.....???For now forget
  about social marketing, firs fix that gaping hole.Get a website you can update yourself, dead
  static and bo...

• Posted in thread: add subfloor in basement bathroom on 05-05-2012 at 03:07 PM
  I'm assuming that you got 4" cast iron stub-out currently flush with concrete slab. Measure
  distance of top of the rubber gasket to bottom of your toilet flange. if you have 2" there you
  will be fine....

• Posted in thread: Washer and Sink drain on 03-31-2012 at 01:11 PM
  Is a kitchen drain vented?. Check the roof above kitchen sink.If you have window above kitchen
  sink there should be a vertical vent pipe on ether side of the window. If the sink is vented,
  run 1 11/2 ...

• Posted in thread: Washer and Sink drain on 03-18-2012 at 01:40 AM
  any pictures?. it would help. Washing machine needs its own, separate trap. Where is the vent
  for all this?

• Posted in thread: Tub faucet brand? on 03-18-2012 at 01:36 AM
  American Standard will do nicely. Looks like you have gone dip enough, so you can install
  whatever mom likes.

• Posted in thread: Custom shower - water lines after valve on 02-25-2012 at 05:41 PM
  what is your pump well pressure, at start of cycle and end of pumping cycle?. to run 3 heads
  you will need at list 55 psi

• Posted in thread: Does this look okay?? on 02-14-2012 at 12:49 PM
  remove Vertical nipple and L-bow. replace L-bow with "T" with extra opening pointing down.
  Screw 4" nipple pointing down and cap it. When you at this increase length of this vertical
  nipple by about 1...

• Posted in thread: Bringing new supply line up through existing slab on 02-13-2012 at 11:33 PM
  You can drill from inside of the garage at angle, so your drill bit comes on outside bellow
  ground level, dig hole outside to fond end of your bit. Keep in mind that depends on your
  location section o...

• Posted in thread: Is this for the city or us? on 02-13-2012 at 12:14 AM
  Water meter valve on street side with padlock holes belongs to the city and should be the
  City's responsibility. As mr_Dave above responded if that valve is not working City should fix
  it.After that y...

• Posted in thread: Help removing tub/shower stem cover on 02-06-2012 at 02:53 PM
  Looks like somebody in the past inserted sleeves before tile job was completed. Use small
  chisel or old screwdriver to chip mortar around sleeves, then try to unscrew them. This old
  faucet should be r...