cast

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. J

    DWV Question for Cast Iron San Tee Replacement

    Hello everyone! Working on a Florida block home built in the 60s that most of the cast iron drains have been replaced in but still a bit lingering around in places we're working to replace. The toilets in the hall bath and master bath are back to back and drain into a 4" cast iron double...
  2. T

    Difficult Flange Problem - Please Advise

    Hello, I have a house that was built in 1962, and we're re-finishing the basement. The current cast iron toilet flange (shown in picture), is 4-3/4" at the opening, and then 3" down it reduces to 3-3/4". I purchased an Oatey Twist-N-Set replacement flange, but it doesn't quite reach down to the...
  3. J

    Brand New Cast Iron shower drain already rusting

    We just got our bathroom remodeled, and a new shower built, and while sealing the grout I noticed that the Cast Iron drain was already rusting. We only used the shower once to test the faucet. What should we do? Is there any way to stop the spreading of rust? Taken through the drain cover...
Back
Top