Shower mixing valve piping

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Jayman

Member
Joined
Dec 16, 2013
Messages
10
Reaction score
0
Location
,
During my remodel I uncovered the shower wall with the existing mixing valve. As you can see in the picture the line entering the valve on the right tee's off and jumps from 1/2 to 3/4" or 1" goes up about a foot and then is capped off. Is there a reason for this? My first thought was that the contractor didn't have a 1/2" elbow and then just stuck this in the arrangement?

mixervalve.jpg
 
I am installing a modern thermostatic mixing valve to replace this one. Its an externally mounted mixer i.e. not in the wall. Would it be appropriate to install this way on both the hot and the cold? Thank you
 
No, those field manufactured shock arrestors don't do any good after awhile. The air above the water is slowly absorbed into the pressurized water. If you want to install shock arrestors, buy the factory made ones with piston seals that have a gas charge in them.
 

Latest posts

Back
Top