W adams & sons bath mixer tap

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

kstranks

New Member
Joined
Sep 21, 2013
Messages
1
Reaction score
0
Location
,
Anyone help, how do you remove the back nut and looking to replace shuttle, where can I get spares?
 
I don't know of any suppliers that have parts. There are some replacement valves available right now on eBay if that helps.
 
Three years too late, but I have the answers.

The hex is approx 37/38mm across flats, but they were installed with Loctite when first assembled. You will need a bit of heat and some good leverage to get it undone. Hold the tap body in the soft jaws of a vice and gently warm the tap with a blowtorch, being careful not to scorch the plating. With a "breaker-bar" use an increasing amount of torque and it will break the seal that the locking compound has created.

You'll need to let me know whether you have a nylon or brass shuttle, as the pin on the cam is sized differently for each model. (unless changed as a pair)

Good luck and get in touch for more details.

Keith
TapRefurbishment.co.uk
 
Back
Top