JacksCanary
New Member
Cut to the chase, my wife had her uncle install a new water heater. This is how it looks now, completed. Is it as horrible a job as I think it is?
Diy installation (completed)- how bad is it?
- Thread starter JacksCanary
- Start date
Help Support Plumbing Forums:
Not good at all. Flue pipe not connected properly, cpvc adapters connected directly to water heater. Turn the gas off to the heater that flue pipe connection is very dangerous.
You can't have any type of plastic piping near the water heater flue there needs to be a minimum distance. Also did he take the flue and smash ut on top of the water heater. You should tell your wife to let her family take care of themselves don't let the uncle touch anything ever again
I 3rd that.
Go purchase a couple of stainless steel flexible water heater supply lines, a couple of 3/4 dielectric nipples for the top of the tank, and two male fittings in CPVC to attach the supply lines to.
The dude could up of used a rag as well
PlumberMike
Active Member
horrible has to least be 18 inches from the top of the tank then u can change pipe material to what ever.
