Pro press

Plumbing Forums

Help Support Plumbing Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
No I'm repairing some leaks in a boiler room and some of my pro press couplings well be tight to the existing solder joints
 
the press does deform the copper a bit but the if the solder joint is good and solid then you can probably get pretty close. it's that joint that has been just barely hanging on that could be the trouble maker.
 
Thanks boys. I ended up just soldering instead. Didn't wanna risk it and end up with a flood 😂
 

Latest posts

Back
Top