My Ice Maker Line

[lafayettenow]

I'm almost positive the copper in in the back behind the pvc is my icemaker. Do you see a way I can do this? See Picture and thanks so much

[Fansplumbing]

That could be your ice maker line. What exactly are you asking, as in, what are you trying to do?

[lafayettenow]

That does come from my ice maker I double checked. I just wanted what my options were getting this copper line connected to a water source. I'm so sorry. I have no idea about doing plumbing.

[SlowDrip]

You could change your cold water shutoff to one that has two outlets, a 3/8" and a 1/4", then run the icemaker line directly to it.

[lafayettenow]

I just come here for plumbing my wife and I just bought a house and I don' know jack crap at 31 about it. Thank you for all your help! I'm going to give it a shot as soon I can. Gosh questions to the right people can makes things very easy sometimes. THANKS AGAIN

[Mr_David]

What ever you do Don't install one of those puncture type saddle valves.
They work and they are easy to install but down the rod they can be a real headache.

[LeakFinder]

How far away is the fridge from where the sink and supply lines are? If it's not too far, you can run a new line, you just may have to drill a few holes in the very BACK of the cabinets to route the new line through. I would not use a small plastic line as they are notorious for causing water leaks and water damage.

[havasu]

Exactly on not using the plastic line. The vibration from the fridge motor put a pin hole in that plastic line at one of my houses and caused alot of damage before I knew it!